Tools necessary for PC assembling

•

For PC assembling you may need the following tools - 
1. A Big table on which you have to assemble your PC.  It must be placed at a place where you can work from every side of the table. 
if it is not possible than work with a table placed in any safe place.

2. A screw driver set, attach different bits on the screw drivers head to prepare sraw driver of different properties.   

3. Flat & noosed Pliers  it is vary necessary.

4. Line tester.

5. Twister.

6. One Knife & blade.

7. A ordinary Digital Multimeter if it is not available you can also use an analog multimeter. It is no necessary for PC Assembling rather it is used in case of any error.

8. An extension board with 5 AMP socket, switch, fuse & indicator. Board must have at list four to five plug. Earth must be strong. Without earthling PC may get hampered.

9.  Some amount of cotton, piece of cloth, spirit, paper & pen. This are not required for PC assembling but if some problem occur after assembling these may be needed. 

This is quite sufficient for PC assembling. An experienced Assembler may not need many of the tools.

Read More ... »

Uses of firewall

•

         Firewall can be either hardware or software. It protects a computer virus, warm, spyware & other infectious software. Pocket filtering, proxy service, checking correctness of the data are the major work of firewall. In windows XP operating system we can find a firewall named inter connection firewall (ICF).To utilize firewall in windows XP
 Go to start menu. > Click on control panel. > Go to network connection option>
 After selecting your required Network Go to Change settings of the connection option.>
 Go to properties> Go to advance>Chose Protect my computer and network option.>
 Go to advance setting.
          
         There you will get three options: Service, security logging, & ICMP.For service user there is active list in the server or net.If you select any service from here then any ICF or internet user can easily use it by entering throw the firewall. after completing the desired work click OK and come out.

         Then go to Start>control penal>windows firewall  >turn windows firewall on or off>turn on
&if the net is slow turn off

Read More ... »

Assemble your own PC in low cost.

•

The materials you would need to make a PC are as follows:-

1. An ATX Cabinet with SMPS.
2. Motherboard & processor. (According to your budget)
3. Hard disk. (With suitable memory)
4. DDR II or III RAM according to your Motherboard.
5. LCD Monitor.
6. DVD drive.
7. UPS.
8. SATA cable & AC Power cord.

At first open the ATX cabinet, you will find some screw. Carefully attach Motherboard in cabinet with the help of screw. Put the RAM on its slot & cheek if all the locks are closed. Open the lock of processor socket & put processor on the socket & close the lock. And attach heat sick & fan on the processor. Connect the fan to Motherboard. Attach hard disk on the cabinet by screw (don't make the screw very tight.) .Attach DVD drive in proper place.

 Now connect Motherboard to the SMPS via 20/24 pin Power jack. Connect power cable to HDD & DVD Drive. Now connect sata cable to hard disk & DVD drive. Insisting on Motherboards guide book  connect HDD LED, Power LED, Power jack & Reset Jack.

Now Connect Monitor signal cable to the Motherboard. Connect Monitor & System box to the UPS. After turn on monitor & System box Go to BIOS option, Select DVD drive as  first boot device & Hard disk as Second boot device. Save your BIOS setting. Insert bootable disk in your DVD drive. Format the hard disk and load operating system. Install the entire Motherboard driver (like Sound, Graphics etc.) 

In case any problem arises plz publish your problem as a comment. I will help you.

Next time I will publish a blog about PC troubleshooting.

Read More ... »